The Gum Case was invented to prevent fifteen piece packs of sugerfree gum from falling apart in pockets and purses. These larger packs of gum were not designed to withstand a couple of days in pockets or purses without support.

When they do spend a couple of days in pant pockets or womens purses they fall apart and get sticks of gum all over the place. Sometimes these sticks of gum fall out of the wrapers and get all of the rest of your items in your pockets or purses sticky and dirty with gum.

So I devised a gum case, with three different parts a pin to hold the lid and case together letting the lid open and close the Gume Case, supporting packs of gum. The lid has a lip on the inside of it that latches onto the outside of the case. The lid, which has a file name of (gumlid1.stl) goes on top of and around the outside of the part (gum.stl) which is the case. The pin named (pin.stl) slids through the holes of the case and lid with the pin head mating up with the counter bore hole on the face of the end hinge of the lid.

After being assembled the case can be reopened and reclosed to slid and hold 15 piece packs of sugar free gum over and over again giving the packs of gum the supprot they've always needed.